Pool Cover Pumps Explained

Pool safety covers are normally used to cover the pool to avoid any mishap in case if any kid or adult fall down in the pool while roaming or playing around. Moreover, it also protects the pool in winters and summers but whenever you think about having a pool cover, you should select the pool cover very carefully. Make sure the pool cover you select meets the standards set by the American Society for Testing and Materials (ASTM). According to ASTM standard F1346-91, the cover must be able to hold at least 485 pounds per 5 sq ft.

Once you make a decision to go for pool covers, you first need to decide whether you want pool covers for protection purpose or for maintenance purpose. There are two types of pool safety covers; one is made of net whereas the other one is solid. Both are used for safety purposes but net pool covers are usually not that effective when it comes to stopping any debris to enter the pool. However, if your only purpose of buying a pool safety cover is to protect your kids and not the pool maintenance then net pool safety covers are good. Solid pool covers are effective in this regard and their major advantage is that it does not allow dirt and other waste material to enter the pool. However, at the same time, a major disadvantage is that in case of rain and snow the water will not drain out which poses a threat, as the cover will sag inside the water that is a danger for kids playing around the pool. Therefore, if you wish to go for solid pool covers, you must also seriously think about buying a cover pump, which will help eliminate the water that is gathered above the pool cover.

While going for solid pool covers, pump is essential, and you need to look at following points while choosing a pool cover:
-If you want your pool cover pump to work effectively whole twelvemonth long, then you must control its power before buying. Heavy duty motorization guarantees long-term operation.
-You must go for a computerized pool cover pump control. This does not require you to run the pump manually whenever water accumulates over the cover but it will detect the water mechanically. Automatic controls normally check for water accumulation every 2.5 minutes.
-Go for strong power cord.
-While picking out strainer base you must go for a wide one. Wide strainer base is very effective and helps keeping debris and waste away thus not allowing it to get stuck in the pump and affect its performance negatively. It will help keep the pump straight.

Keeping in view the preceding points, your pool cover pump selection goes easy. Installing a pool cover pump is quite simple and it just needs a few minutes. To ensure that your pool cover pump runs effectively and for its long life you must be sure that you keep it decently and regularly.

Related posts:

1. Swimming Pool Safety: Cover It Up
2. Q&A: I just got a mesh safety pool cover installed. I got it to keep my lab safe. Now he lays on the cover.?
3. Rule H53SP-24 Marine Rule 1800 Pool Cover Pump with 24-Foot Cord/Wide Base (110-Volt)
4. Best Inground pool Solid Safety Cover?
5. Best Pool Safety Cover - loop Loc etc….?